#Air compressor vibration isolators series
#Air compressor vibration isolators free

Australia Post Express parcels – depending on your location, allow approx.

Air Bag deliveries - allow 2-3 business days.

Standard neoprene pad does not have bolt holes.

Bolt holes shall only be provided for areas where bolting is required.

Multi layered with greater deflection are available.

Standard pad size 150 x 75 x 20 mm thick or 75 x 75 x 20 mm thick.

Neoprene pad are produced from high quality oil, water and corrosion resistant elastomer. It is recommended to isolate noise and vibration in non critical installation such as AHU, Cooling Tower, Chillers, Pumps, Pipe Support and Machinery Equipment. SPPAD / MSH neoprene pad are designed to provide excellent noise and vibration reduction generated by mechanical equipment.

Economical alternative to spring hanger.

Designed to attenuate high frequency vibration.

It consist of steel a steel casing, compression spring, and incorporated a neoprene element which can isolate both vibration and structure born noise.

#Air compressor vibration isolators series

SPH Series isolators are designed to isolate vibration for suspended equipment and piping system such as fans, fan coil unit, AHU, duct work etc.

Spring Hanger consist of neoprene element at the top hanger box and rubber sleeve at the bottom of the box to prevent vibration short circuit.

Spring diameter and hanger box are designed to give allowance for hanger rod to swing thru 30 ° arc before contacting the lower hole which will cause vibration short circuit.

Neoprene element permits vibration isolation for both vibration and structure born noise.

Rated deflection ranging from 25mm up to 75mm.

SNH is an economical alternative to spring hanger and may be selected to minimize cost. These hanger are designed to attenuate high frequency problem. The isolator consist of a steel casing and a neoprene element in shear insert with a load plate.

SNH Neoprene Hanger are designed to isolate vibration for suspending equipment and pipe system. Multi spring design with metal plate at top leveling and base which comes with rubber sleeve at top and bottom of the spring to prevent vibration short circuit through springs.Single spring designed with metal top leveling cup for durability and includes rubber sleeve to prevent vibration short circuit through the spring.Built in leveling device simplified installation.It is recommended for direct usage under most equipment which in conjunction to structural steel bases or concrete inertia block. SPUM Seris isolators designed to isolate both high frequency vibrations in Air Handling Unit, Compressors, Pumps and other HVAC equipment. All springs designed to have additional travel to solid equal to 50% of rated load.Includes rubber bushing at restraining stud to prevent vibration short circuit through studs.Base mount designed with water drainage hole to prevent water collection from wet weather.Tapped holed are provided for easy mounting.Color coded steel spring coil for ease of identification & installation.Steel housing provide same installation and operating height.Rated deflection ranging from 25mm up to 100mm.The steel housing is designed to limit movement in all directions due to wind load and large external forces.

#Air compressor vibration isolators free

SPRM Series isolator are specifically designed with free standing springs assembled into a welded steel housing.

Our Vibration Isolation product comes in all types and sizes to suit different kind of environment and application. With continuing development, SPECTRUM isolator has a wide range of products for different type of application. SPECTRUM Vibration Isolation products are specifically designed to provide the best solution for vibration & noise attenuation.